Victron Energy ASS070200100 Smart BMS CL 12-100 to MultiPlus Control Cable

Cable for Smart BMS CL 12-100 to MultiPlus

This cable will allow the MultiPlus 500VA 1600VA, MultiPlus Compact 800VA 2kVA and MultiPlus-II models to be used with BMS products that have no VE.Bus interface, such as the Smart BMS CL 12-100 and the small BMS. These MultiPlus models can be controlled from the Load/Charge Disconnect outputs and Load/Charger outputs respectively.

The cable must be wired to the remote on/off connector of the MultiPlus models:

• When used with the MultiPlus 500VA-1200VA models connect the black wire to the ON terminal and the red wire to the (+) terminal.


• When used with the MultiPlus Compact 800VA-2kVA models connect the black wire to the middle terminal and the red wire to the right (IN) terminal.


• When used with the MultiPlus-II models connect the black wire to the lower (-) terminal and the red wire to the upper (+) remote on-off terminal.

Both the Load/Charge Disconnect outputs of Smart BMS CL 12-100 and Load/Charger outputs of the small BMS must be in High state in order for the MultiPlus to operate. After shutdown due to low battery voltage, run the alternator or use a battery charger on the primary side of the BMS to reset the system. The MultiPlus will then switch on and start charging (if connected to an AC power source).

The Victron Energy ASS070200100 cable is designed to facilitate communication between Smart BMS CL 12-100 systems and various MultiPlus inverter/chargers, including models from 500VA up to 2kVA. This cable enables seamless control and monitoring, allowing users to manage their power systems efficiently even without a VE.Bus interface on their BMS. It is compatible with multiple MultiPlus models, such as the MultiPlus 500VA to 1600VA, MultiPlus Compact 800VA to 2kVA, and MultiPlus-II series, making it a versatile solution for various energy management setups. The cable connects to the remote on/off terminals of the MultiPlus units, with wiring instructions tailored to each model for straightforward installation. For the MultiPlus 500VA-1200VA, connect the black wire to the ON terminal and the red wire to the (+) terminal. For the Compact models from 800VA to 2kVA, connect the black wire to the middle terminal and the red wire to the right (IN) terminal. The MultiPlus-II models require connecting the black wire to the lower (-) terminal and the red wire to the upper (+) remote on-off terminal. Proper operation depends on the Smart BMS's Load/Charge Disconnect outputs being in a high state, which allows the MultiPlus to operate correctly. If shutdown occurs due to low battery voltage, resetting the system involves running the alternator or using a battery charger on the primary side of the BMS, after which the MultiPlus will restart and begin charging if connected to AC power. This cable is essential for integrating BMS with Victron MultiPlus systems, ensuring reliable power management and system control. Please consult your dealer for support, repairs, or returns related to this product to ensure proper handling and compatibility.

Features:

• Compatible with Victron MultiPlus 500VA to 2kVA inverter/chargers

• Facilitates communication between Smart BMS CL 12-100 and MultiPlus models

• Connects to remote on/off terminals for seamless control

• Wiring instructions tailored for different MultiPlus models

• Ensures reliable operation by requiring high state signals from BMS outputs